This product is no longer available and has been replaced by:105E-L.
| Services Available | |
|---|---|
| Repair | No |
| Calibration | No |
| Free Support | No |
Overview
The 105T Type T thermocouple consisted of 24-gage, shielded, copper wire and constantan wire. The copper wire and constantan wire were joined at a measurement junction that was electrically isolated from the soil (or other media). Electrical isolation avoided measurement errors due to differences in ground potential.
Images
Compatibility
Note:The following shows notable compatibility information. It is not a comprehensive list of all compatible or incompatible products.
Data Loggers
| Product | Compatible | Note |
|---|---|---|
| 21X(retired) | ||
| CR10(retired) | ||
| CR1000(retired) | ||
| CR10X(retired) | ||
| CR200(retired) | ||
| CR205(retired) | ||
| CR206(retired) | ||
| CR210(retired) | ||
| CR211(retired) | ||
| CR215(retired) | ||
| CR216(retired) | ||
| CR23X(retired) | ||
| CR295(retired) | ||
| CR3000(retired) | ||
| CR500(retired) | ||
| CR5000(retired) | ||
| CR510(retired) | ||
| CR800 | ||
| CR850 | ||
| CR9000(retired) | ||
| CR9000X(retired) |
Additional Compatibility Information
The 105T is measured by the TCDiff instruction in CRBasic and by Instruction 14 (Differential Thermocouple) in Edlog. One differential channel per probe is required; a thermocouple reference junction at the data logger is also required. If large numbers of 105Ts are to be measured, the AM25T Thermocouple Multiplexer is recommended. The CR200-series, CR500, and CR510 dataloggers do not have thermocouple measurement instructions and are therefore not compatible with the 105T.
Documents
Brochures
Frequently Asked Questions
Number of FAQs related to105T-L:2
-
信息包含在校准表differs with each sensor. For some sensors, the sheet contains coefficients necessary to program a data logger. For other sensors, the calibration sheet is a pass/fail report.
-
This depends on the information contained in the calibration sheet:
- If the calibration sheet contains coefficient information, Campbell Scientific keeps a copy, and a replacement copy can be requested.
- If the calibration sheet does not contain coefficients, Campbell Scientific does not keep a copy. It may be possible to contact the original manufacturer for a replacement copy.